#CISCO USB CONSOLE DRIVER WINDOWS 10 INF INSTALL#

Step 1 If you are connecting the switch USB console port to a Windows-based PC for the first time, install the USB driver according to these instructions. You can initially configure the entire stack from any member switch.Ĭonnecting the RJ-45 Console Port or USB Console Port Note If you have stacked your switches, connect to the console port of one of the switches in the stack. You can access the CLI on a configured or unconfigured switch by connecting the RJ-45 console port or USB console port of the switch to your PC or workstation and accessing the switch through a terminal emulation program. Accessing the CL I Through the Console Port You lose the Telnet connection after entering the write memory command.įor information about using the CLI, see the switch command reference for this release.

Note In Express Setup mode, the IP address 10.0.0.1 remains active on the switch until you enter the write memory command. Enter the information described in the “IP Settings” section and the “Completing the Setup Program” section.Īfter you have entered the configuration information for the switch, save it to flash memory by using the write memory privileged EXEC command. When the switch is in Express Setup mode, open a Telnet session to the switch by entering the IP address 10.0.0.1. Follow the steps described in the getting started guide for turning on the switch and using Express Setup. Set the switch in Express Setup mode and connect a switch Ethernet port to an Ethernet port on your PC or workstation.

You can access the CLI on an unconfigured switch.

Cisco usb console driver windows 10 inf